Ethernet fails just for seconds

Posted on

Ethernet fails just for seconds – Managing your servers can streamline the performance of your team by allowing them to complete complex tasks faster. Plus, it can enable them to detect problems early on before they get out of hand and compromise your business. As a result, the risk of experiencing operational setbacks is drastically lower.

But the only way to make the most of your server management is to perform it correctly. And to help you do so, this article will share nine tips on improving your server management and fix some problem about linux, linux-networking, ethernet, , .

I have a clearos gateway linux working as gateway. I have some problems with the conectivity, everything works great but for a few seconds internal ethernet stops working. After 5-10 seconds, it works again.

I did a ping to internet and from the gateway I didn’t find any packet lost, but from a computer in the intranet I get some problems:

Request timeout for icmp_seq 94
92 bytes from mygateway.ar7 ( Destination Net Unreachable
Vr HL TOS  Len   ID Flg  off TTL Pro  cks      Src      Dst
 4  5  00 5400 81f5   0 0000  40  01 054f

This is my ifconfig eth2

eth2  Link encap:Ethernet  HWaddr XX:XX:XX:XX:XX:XX  
      inet addr:  Bcast:  Mask:
      inet6 addr: fe80::212:79ff:fe5f:c291/64 Scope:Link
      RX packets:7525730 errors:0 dropped:0 overruns:0 frame:0
      TX packets:8134818 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:1000 
      RX bytes:3353100361 (3.1 GiB)  TX bytes:3048405269 (2.8 GiB)
      Interrupt:169 Memory:f0400000-f0410000 

What can be the problem? Local DNS server? Switch? Network loop?

Any idea?


Solution :

92 bytes from mygateway.ar7 ( Destination Net Unreachable

This right here means that the problem isn’t on your local network. Your internal machine is getting a reply from your gateway saying that the internal machine can’t reach the destination network.

You’ve already said the gateway itself doesn’t have problems so the problem is likely due to some sort of policy. Does it have any sort of connection or ICMP throttling in place?

You may have a disabled port on another server that has a duplicate IP configured. I have seen numerous times that even disabled ports will cause intermittent IP address conflicts. I know it sounds ridiculous but the problem has always gone away when I remove the address info instead of just allowing the OS to grey them out. Its worth a try.

Leave a Reply

Your email address will not be published.